root@TViX:~$ cat /proc/cpuinfo system type : Sigma Designs TangoX processor : 0 cpu model : MIPS 4KEc V6.9 Initial BogoMIPS : 291.84 wait instruction : yes microsecond timers : yes tlb_entries : 32 extra interrupt vector : yes hardware watchpoint : yes ASEs implemented : mips16 VCED exceptions : not available VCEI exceptions : not available System bus frequency : 198000000 Hz CPU frequency : 297000000 Hz DSP frequency : 297000000 Hz root@TViX:~$ free total used free shared buffers Mem: 79416 51436 27980 0 0 Swap: 0 0 0 Total: 79416 51436 27980 root@TViX:~$ dmesg Linux version 2.6.15-sigma (tvix@metallica.dvico.com) (gcc version 4.0.4) #147 PREEMPT Fri Oct 10 15:16:57 KST 2008 Configured for SMP863x (revision ES6/RevA), detected SMP8635 (revision ES9/RevC). SMP863x/SMP865x Enabled Devices under Linux/XENV 0x48000000 = 0x00003ef6 BM/IDE PCIHost IR FIP I2CM I2CS USB PCIDev1 PCIDev2 PCIDev3 PCIDev4 Valid MEMCFG found at 0x10000fc0. CPU revision is: 00019069 Determined physical RAM map: memory: 054e0000 @ 10020000 (usable) On node 0 totalpages: 87296 DMA zone: 87296 pages, LIFO batch:15 DMA32 zone: 0 pages, LIFO batch:0 Normal zone: 0 pages, LIFO batch:0 HighMem zone: 0 pages, LIFO batch:0 Built 1 zonelists Kernel command line: console=ttyS0 Primary instruction cache 16kB, physically tagged, 2-way, linesize 16 bytes. Primary data cache 16kB, 2-way, linesize 16 bytes. Synthesized TLB refill handler (20 instructions). Synthesized TLB load handler fastpath (32 instructions). Synthesized TLB store handler fastpath (32 instructions). Synthesized TLB modify handler fastpath (31 instructions). PID hash table entries: 2048 (order: 11, 32768 bytes) Using 148.500 MHz high precision timer. Console: colour dummy device 80x25 Dentry cache hash table entries: 65536 (order: 6, 262144 bytes) Inode-cache hash table entries: 32768 (order: 5, 131072 bytes) Memory: 76160k/86912k available (3249k kernel code, 10696k reserved, 930k data, 3200k init, 0k highmem) Calibrating delay loop... 291.84 BogoMIPS (lpj=145920) Mount-cache hash table entries: 512 Checking for 'wait' instruction... available. NET: Registered protocol family 16 tangox: creating TLB mapping for 0x20000000 at 0xc0000000, size 0x08000000. PCI: Initializing SMP863x/SMP865x PCI host controller PCI: Remapped PCI I/O space 0x58000000 to 0xc8020000, size 64 kB PCI: Remapped PCI config space 0x50000000 to 0xc8004000, size 10 kB PCI: Configured SMP863x/SMP865x as PCI slave with 128MB PCI memory PCI: Region size is 16384KB PCI: Map DMA memory 0x10020000-0x15500000 for PCI at 0x11000000 SCSI subsystem initialized usbcore: registered new driver usbfs usbcore: registered new driver hub tangox frequency scaling module installed. Created /proc/cpucache_info entry. JFFS2 version 2.2. (C) 2001-2003 Red Hat, Inc. Initializing Cryptographic API io scheduler noop registered io scheduler anticipatory registered io scheduler deadline registered io scheduler cfq registered SMP863x ir (254:0): driver loaded (wait_period = 100ms, buffer_size = 6) Software Watchdog Timer: 0.07 initialized. soft_noboot=0 soft_margin=60 sec (nowayout= 0) Serial: 8250/16550 driver $Revision: 1.90 $ 2 ports, IRQ sharing disabled serial8250: ttyS0 at MMIO 0x0 (irq = 9) is a 16550A serial8250: ttyS1 at MMIO 0x0 (irq = 10) is a 16550A loop: loaded (max 8 devices) physmap flash device CS2: 4000000 at 48000000 CS2: Physically mapped flash: Found 1 x16 devices at 0x0 in 16-bit bank Amd/Fujitsu Extended Query Table at 0x0040 CS2: Physically mapped flash: CFI does not contain boot bank location. Assuming top. number of CFI chips: 1 cfi_cmdset_0002: Disabling erase-suspend-program due to code brokenness. Using physmap partition definition Adding partition #1-#12 Creating 12 MTD partitions on "CS2: Physically mapped flash": 0x00000000-0x00020000 : "CS2-Part1" 0x00020000-0x00040000 : "CS2-Part2" 0x00040000-0x00240000 : "CS2-Part3" 0x00240000-0x00260000 : "CS2-Part4" 0x00260000-0x00280000 : "CS2-Part5" 0x00280000-0x002a0000 : "CS2-Part6" 0x002a0000-0x002c0000 : "CS2-Part7" 0x002c0000-0x002e0000 : "CS2-Part8" 0x002e0000-0x00300000 : "CS2-Part9" 0x00300000-0x00d00000 : "CS2-Part10" 0x00d00000-0x02c00000 : "CS2-Part11" 0x02c00000-0x04000000 : "CS2-Part12" driver tangox-ehci-hcd, 10 Dec 2004 TangoX USB initializing... tangox-ehci-hcd tangox-ehci-hcd: TangoX USB 2.0 tangox-ehci-hcd tangox-ehci-hcd: new USB bus registered, assigned bus number 1 tangox-ehci-hcd tangox-ehci-hcd: irq 48, io mem 0xa0021500 tangox-ehci-hcd tangox-ehci-hcd: USB 0.0 started, EHCI 1.00, driver 10 Dec 2004 hub 1-0:1.0: USB hub found hub 1-0:1.0: 2 ports detected TangoX USB was initialized. Initializing TangoX USB OHCI Controller Membase=0xa0021500, irq=47 tangox-ohci-hcd tangox-ohci-hcd: USB Host Controller tangox-ohci-hcd tangox-ohci-hcd: new USB bus registered, assigned bus number 2 tangox-ohci-hcd tangox-ohci-hcd: irq 47, io mem 0xa0021500 hub 2-0:1.0: USB hub found hub 2-0:1.0: 2 ports detected usb 1-1: new high speed USB device using tangox-ehci-hcd and address 2 Initializing USB Mass Storage driver... hub 1-1:1.0: USB hub found hub 1-1:1.0: 4 ports detected usbcore: registered new driver usb-storage USB Mass Storage support registered. NET: Registered protocol family 2 IP route cache hash table entries: 4096 (order: 2, 16384 bytes) TCP established hash table entries: 16384 (order: 4, 65536 bytes) TCP bind hash table entries: 16384 (order: 4, 65536 bytes) TCP: Hash tables configured (established 16384 bind 16384) TCP reno registered TCP bic registered NET: Registered protocol family 1 NET: Registered protocol family 17 ieee80211: 802.11 data/management/control stack, git-1.1.7 ieee80211: Copyright (C) 2004-2005 Intel Corporation ieee80211_crypt: registered algorithm 'NULL' Freeing unused kernel memory: 3200k freed r8169 Gigabit Ethernet driver 2.2LK loaded PCI: Enabling device 0000:00:02.0 (0000 -> 0003) PCI: Setting latency timer of device 0000:00:02.0 to 64 eth0: Identified chip type is 'RTL8169s/8110s'. eth0: RTL8169 at 0xc801e000, 00:01:04:a5:20:87, IRQ 22 r8169: media option is deprecated. 8139too Fast Ethernet driver 0.9.27 SMP863x fip (241:0): driver loaded (g_buffer_size = 2) llad: module license 'LGPL' taints kernel. em8xxx: no version for "llad_open" found: kernel tainted. em8xxx [/ccrc/build_view/TVIX/m-6x00/mrua/MRUA_src/rua/emhwlib_kernel/kernel_src/krua.c:1557] init_module: begun em8xxx0 [/ccrc/build_view/TVIX/m-6x00/mrua/MRUA_src/rua/emhwlib_kernel/kernel_src/krua.c:1440] identify: board as unknown subid em8xxx [/ccrc/build_view/TVIX/m-6x00/mrua/MRUA_src/rua/emhwlib_kernel/kernel_src/krua.c:1543] identify: device 0x8635 0x86 accepted with software tango2revA em8xxx [/ccrc/build_view/TVIX/m-6x00/mrua/MRUA_src/rua/emhwlib_kernel/kernel_src/krua.c:1649] Allocated channel index table @ 0x177ffcd4 em8xxx [/ccrc/build_view/TVIX/m-6x00/mrua/MRUA_src/rua/emhwlib_kernel/kernel_src/krua.c:1653] mumk_register_tasklet 0xc8095000 mumk_register_tasklet: (0) tasklet c8095000 status @cc295d64 em8xxx [/ccrc/build_view/TVIX/m-6x00/mrua/MRUA_src/rua/emhwlib_kernel/kernel_src/krua.c:1778] init_module: done. Found 1 em8xxx Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx ide0: SMP863x/SMP865x Bus Mastering IDE controller Probing IDE interface ide0... hda: WDC WD10EACS-65D6B0, ATA DISK drive hda: set to Ultra DMA mode 6 ide0: DMA enabled for ATA DISK hda ide0 at 0x223c0-0x223c7,0x22398 on irq 26 hda: max request size: 128KiB hda: 1953525168 sectors (1000204 MB) w/16384KiB Cache, CHS=65535/255/63 hda: cache flushes supported hda: hda1 nlsconv module is loaded with nls_code(cp949) utf16conv module is loaded with nls_code(cp949) usbcore: registered new driver rt73 usbcore: registered new driver tvixdtv tvixdtv: tvixdtv module is loaded ir: Enable NEC decoder (0x00000000) ir: Enable RC5 decoder (0x00000000) ir: Enable RC6 decoder ufsd: driver loaded UFSD version 6.02 (Nov 1 2007, 18:13:10) NTFS read/write support included $Id: ufsdvfs.c,v 1.121 2007/10/24 17:22:04 shura Exp $ ufsd: address 0xcc11b000 r8169: eth0: link up r8169: eth0: link up ufsd: failed to mount hda FAT: bogus number of reserved sectors VFS: Can't find a valid FAT filesystem on dev hda. VFS: Can't find ext3 filesystem on dev hda. VFS: Can't find an ext2 filesystem on dev hda. Unable to identify CD-ROM format. attempt to access beyond end of device hda: rw=0, want=1953525172, limit=1953525168 attempt to access beyond end of device hda: rw=0, want=1953525172, limit=1953525168 UDF-fs: No partition found (1) r8169 Gigabit Ethernet driver 2.2LK loaded eth0: Identified chip type is 'RTL8169s/8110s'. eth0: RTL8169 at 0xc80c8000, 00:01:04:a5:20:87, IRQ 22 r8169: media option is deprecated. r8169: eth0: link down r8169: eth0: link up r8169: eth0: link up nlsconv module is reloaded with nls_code(iso8859-1) utf16conv module is reloaded with nls_code(iso8859-1) ufsd: failed to mount hda FAT: bogus number of reserved sectors VFS: Can't find a valid FAT filesystem on dev hda. VFS: Can't find ext3 filesystem on dev hda. VFS: Can't find an ext2 filesystem on dev hda. Unable to identify CD-ROM format. attempt to access beyond end of device hda: rw=0, want=1953525172, limit=1953525168 attempt to access beyond end of device hda: rw=0, want=1953525172, limit=1953525168 UDF-fs: No partition found (1) Algorithmics/MIPS FPU Emulator v1.5